Reconditioning of Nirex Fresh Wate Generator
We offer Freshwater generators on service exchange basis.This means a totally remanufacturing. When we remanufacture a Fresh Water Generator, we strip it totally down and put all parts except plates in an oven to get rid off the chlorites trapped in the steel. When the items are out off the oven it is sandblasted to SA2½. If there is a hole in the casing the area is cut out and replaced with new plate. All plates in heater and condenser are chemically cleaned, crack tested, and any bad plates will be replaced, and mounted with new gaskets. All other gaskets and bolts are replaced aswell. After repair on the casing, it is sandblasted again to SA2½. All small corroded areas are rebuild with Nordtec Ceramic Rapid. The internal of the Fresh Water Generator is coated with 2 layers of Nordtec Ceramic 2212 FDA (Food grade coating). Nordtec Ceramic 2212 FDA is developed for Food, Fresh water plants and Freshwater generators. Nordtec Ceramic 2212 FDA is designed as an abrasion resistant and fluid flow ceramic coating. Nordtec Ceramic 2212 FDA coating is reinforced with ceramic and carbide particles to obtain a high level of abrasion and erosion resistance and physical, mechanical strength. The outside of the Fresh Water Generator, is primed and coated with a two component paint. We deliver gaskets for the following fresh water generators: Nirex Alfa Laval Serck Atlas Denmark Sasakura. For further information contact Nordec. |
   |
   |